Roland D50 sysex

Ok here is my issue and I could use some help, please I have a Roland D50 and I am trying to setup a cc control to change the partial balance of the upper and lower sounds via sysex or cc messages.

I found this on the internet yet I could not figure it out with reacontrilmidi or anything else i have found on the internet.

Again any help would be greatly appreciated.

or sysx from your midi controller use these (mapped to 3 2D knobs to simulate what the joystick does) obviously if you had some way of using a physical joystick that blends between values like the orginal stick does then set it up for that.

for U/L tone balance (HEX):

Code:

$f0 $41 $00 $14 $12 $00 $03 $21 val $39 $f7

For lower tone partial balance:

Code:

$f0 $41 $00 $14 $12 $00 $01 $2F val $2E $f7

For upper tone partial balance:

Code:

$f0 $41 $00 $14 $12 $00 $02 $6F val $54 $f7


val = your midi controllers adjustable range assigned to the nob (0-100 range)

with this on 3 knobs ( just tested it) it reproduces the same thing the stick does. Not that handy on 3 knobs vs one stick but it does work.

I also have set up a multi line command to a couple of knobs to simulate global cut off, global res, global PWM and global PWM DEPTH (Also have these on other per partial knobs) as you can get on the PG-1000 which can be handy - for those interested:

Code:

$f0 $41 $00 $14 $12 $00 $00 $0D val $30 $f7
$f0 $41 $00 $14 $12 $00 $02 $0D val $30 $f7
$f0 $41 $00 $14 $12 $00 $01 $4D val $30 $f7
$f0 $41 $00 $14 $12 $00 $00 $4D val $30 $f7

put all four lines in to ONE knob's function (using it's software editor in the case of the BCR) this gives global cof for all four partials at once (set to same VAL). If anyone wants more details for other parameters just ask as I've got them all working. I could just provide the BCR preset but it's not fully to my liking yet (all light times/button ranges and speed/resolutions)

Roland D50 sysex